Description
Apply to single color LED controller.
Ultra sensitive color adjustment touch slide.
Each remote can match one or more receiver.
CR2032 battery powered.
Operate with LED indicator light.
Magnet on the back which can be easily stuck on back holder or any metal surfaces.
TECHNICAL DETAILS
Input voltage: 5-36VDC
Input current: 8.5A
Output voltage: 5-36VDC
Output current: 1CH,8A
Output power: 40W/96W/192W/288W (5V/12V/24V/36V)
Output type: Constant voltage
IP rating: IP20
Input signal:RF 2.4GHz + Push Dim
Dimming range:0 -100%
Control distance:30m
Dimension:
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote' back holder on the wall with two screws.
Option 3: adhere the remote' back holder to the wall with paster
Operation
To extend battery life, no operation after 20 seconds, the touch slide will enter sleep state.
If the light is on, long press on/off key exceed 1 second, then touch slide to dimming.
If the light is off, short press on/off key to turn on light, then touch slide to dimming.
Key function:
Safety information:
1. Read all instructions carefully before you begin this installation.
2. When installing battery, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery.
3. If no response from the receiver, please re-match the remote.
4. Gently handle remote, beware of falling.
5. For indoor and dry location use only.
Wiring Diagram:
